Mesa Game was not starting up correctly. Displays would show garbage and random solenoids would fire. Checked out the circuit boards and the batteries had leaked onto 40 pin interconnect and 1 chip. All battery corrosion was cleaned off , 40 pin interconnect was replaced and a remote battery holder installed. Socketed and replaced the […]
Phoenix Game just needed to be cleaned, re-rubbered, new pop bumper aprons and some new bulbs. Went to turn on the machine and the switch did not turn it on, checked the fuse, switch and transformer and still no power, finally saw the circuit breaker next to the on/off switch and resetting that fixed it […]
Scottsdale, AZ Info to be added later
Peoria, AZ This game is in queue for a Firebird Restoration. In the meantime the owner wanted a few things patched up until it comes time to restore it. One pop bumper was shattered, flippers were weak and the strobe unit was missing from the game and he purchased a non-operable used one from RGP. Flash […]
Chandler AZ, Not a complicated set of repairs on this one. Customer had some bad switches and suspected that the magnet for the basket ball wasn’t working. Also the playfield was leaning heavily to the right. Opened the pf and found our first problem immediately. The playfield pivot bracket had fallen off the right side […]
PHOENIX, AZ Game did not want to boot at all. The voltage at the MPU was only 4.6 volts and it was 4.8 volts at the driver board. Both of these are too low for the game to boot. The first issue was the voltage drop between the two boards. On some of Williams more […]
Peoria, Arizona This was another new addition to this customer’s gameroom. The machine was right off route and wasn’t booting all the way. Game would start and send a check fuse messae for F114 and F115. Checked all the fuses in the game and indeed F115 was bad, replaced this and the game booted. The […]
Peoria, Arizona Customer had just picked up the pin and wanted me to go over it and make it 100% The first issue was an Odd booting problem. When you turned the game on it would sometimes not boot, It would sometimes report a U10 error, and sometimes report a memory protect failure. If you […]
Chandler, Arizona This was a quick fix. The left slingshot was not working well. It would only activate if the ball hit the bottom of the rubber. Looking at the switch one of the blades had broken off so the switch will never activate. Luckily we stock this switch so after pulling the old switch […]
Peoria, Arizona Game was reported to have a severe reset problem. The game would reset anywhere from withing 10 seconds to 5 minutes after turning it on. We turned this game on and let it run while repairing the TOM. It didn’t reset once. Of course, that’s the way it always works once you have the tech […]